I would like to ask you for a help with operation of aerial receiver BENDIX RA-1B.
In the manual to this receiver I found out, that PL-3 has devided conectors: 16 - 18 (grounding), 19 – voltage +20V to the conector J6, A+; 15 - ON/OFF; switch; 17 - TEL, Jack, to DYN Conn, 14 - HT+ on J7, B+
In the manual they write: “ the total plate current for the receiver is approximatelz 70 mA , voltage 225 V.
It means, that if I want to use RA-1B without genemotor type MP-5 only with extern power supply, how I can separate the voltage on PL-3?
How `s the anode-voltage? 225V direct current? Where is this suppose to be hooked up?
Thank you very much for your help.