Return to Index  

I don't think so.....

July 4 2009 at 6:34 PM		Doug Owen  (Login DKOwen)
YC


Response to Will the Archer Airguns over-sized bolt handle fit a Crosman 1760?
The 1760 uses the same basic bolt as the 22XX guns, right?

The Archer unit is made for QBs (and probably CR 160s) and is entirely different. It's over two inches long, about .300 in diameter (I think bigger than the whole bolt diameter in your gun?) and is held in by a setscrew from the rear.

Sorry, but I think you're SOL. Good show you checked.

Doug Owen

 
 Respond to this message   
Click The Banner To Visit Sportsmantarget

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..