Return to Index  

perhaps there are variations in piercing pin to housing clearances

August 3 2010 at 10:42 PM
Cal  (Login CalG)
AR&P


Response to QB

Certainly an easy change to make.

a simple sleeve that extended the bearing surface against the pin would serve very nicely.

Oh Heck, now I'll need to get a tub of old valve parts to tinker with. wink.gif

 
 Respond to this message   

 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..