Chinese Airgun Forum: instead of solder, a tiny worm of duct seal, on the valve body rear face

Return to Index

instead of solder, a tiny worm of duct seal, on the valve body rear face August 12 2010 at 12:50 AM		scot laughlin (Login classicalgas) YF
Response to Put a piece of solder up inside and pull the trigger

I suspect you'll find not much more that one stem diameter of travel(at least until gas pressure drops below normal)

Respond to this message

Responses

The end block (0200) - Cal on Aug 12, 2010, 11:00 AM

Correct, Cal...I was thinking of almost every other pcp I've worked on this year - scot laughlin on Aug 12, 2010, 11:57 PM

D I S C L A I M E R JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..