Return to Index  

Got my tap yesterday. made up the jig bits and got the shroud off

October 19 2010 at 11:27 AM
  (Login Voltar1)
YFOT


Response to Any B40 .177 shooters out there?

took a fair bit of heat AND force to get that sucker seperated.

not sure of the force but the ram pressure to 1,000psi before I got movement.
setup on my lathe with a rod threaded for the barrel arranged to pull the barrel. A gear puller hydraulic ram to push on the sleeve and a rod into the muzzle to help hold the barrel still.

Cleaned off the goop and worked over the crown and breech leade. Used a setscrew to hold the shroud in place.

Will be shooting it today to see if I did any good happy.gif

Walter....

 
 Respond to this message   

 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..