Chinese Airgun Forum: Just clarification for a novice trigger mechanic

Return to Index

Just clarification for a novice trigger mechanic December 12 2010 at 12:14 AM		(Login rzrbax) YC
Response to Spring plungers from McMaster Car

So, you drilled and tapped both the trigger spring and overtravel holes on a QB to 10-32 then inserted the McMaster Carr part no. 3126A53 in both holes and adjusted from there? It sounds like an easy and inexpensive solution to make the QB trigger more consistent. Thanks for sharing! Bill Dempsey [email protected]

Respond to this message

Responses

To clarify - Cal on Dec 12, 2010, 5:37 PM

D I S C L A I M E R JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..