Return to Index  

Valve stem length

December 25 2010 at 1:42 PM

  (Login critter99)
YF


Response to Lighter striker!!!!

...I have a delrin valve just took it out of
tube the stem protrudes( on hammer side) .166 further than the brass
headed stock valve. Its the way Jack Cuts the valve seat and shape of the delrin head

Should I trim this down to match the length of the stock valve stem?

I will still have to reduce the OD of the modified valve body rear half to fit this tube its tight inside...maybe by .003


    
This message has been edited by critter99 on Dec 25, 2010 1:46 PM


 
 Respond to this message   
Responses


 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..