Return to Index  

O ring groove

February 25 2012 at 1:20 PM
Anthony R  (Login fivestar45)
YF


Response to Yeah, I thought about that...

needs to be cut into the main brass part of the valve. The o ring that seals the incoming side of the valve takes care of any leakage on that side of the port hole, you have to add a groove on the other side of the port hole. That will take care of the momentary blast leakage that you get when you shoot the gun.
Your gun is shooting way too slow, shortening the striker stroke can steal quite a bit of power, also I saw a post somewhere that stated that the T port leakage costs 50fps.

 
 Respond to this message   
Responses


 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..