Return to Index  

Sorry Ray

January 18 2017 at 6:16 PM
Tom Mace  (Login TOMMACE)
YF12


Response to I think I'm done !!

I was hoping to get it going for you. But Troy has got it so screw up the only way to get it going is cut off about 8in and put all the holes and slots back where they should be. He put the holes and slots in the air tube with a dremel hand grinder slots were put on angel the holes were big enough for two screws. Valve was cut off and the spring was on the outside which is ok if you don't have the return spring stopping the hammer from opening the valve. The hammer spring looked like it was a spring off from a bed frame. It is in bad repair like I said the air tube can be cut off and the holes and slots you could make it work a new breech should be ok but the thing has dremel marks all over it where it got away from him. It is a sorry mess lets hear it for mister f up.
Ray I want to thank you for the good words But I am sorry that I could not make work. Thank you Tom Mace

 
 Respond to this message   
Responses


 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..