Return to Index  

Re: Grips

April 30 2017 at 11:53 AM

cobalt  (Login cobalt327)
YF12


Response to Grips

I've found only a few photos of modified grips online. I'm going to take a lot of wood from the rear of the grip to 'stand up' the profile as much as possible- I just find the broken-wrist hold of the factory grip VERY unnatural. In the photo below you can just make out the lines from a pattern I made from a Ruger Mark .22. The Ruger has about the most laid-back angle of any grips I have, and like. So I figured patterning the angle to the Ruger grips might make the CP-1M more comfortable. I expect to do a LOT of trial fitting before I'm done but I believe it will be well worth it.

[linked image]

Here's one a fellow did down below this post:

[linked image]

This is from GTA:

[linked image]


 
 Respond to this message   

 

D I S C L A I M E R
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums by people under 18 years old is allowed only with legal guardian(s) present..