There are so many options I need help! Which is the best, most efficient way of doing this? I want to change to bulk air, but don't know what is the best way to go about it. Any help is much appreciated.
#1. If your intention is to pressurize the gun's tube and use it like a PCP, then buy a new PCP pressure rated tube.
#2. If your want to physically hang a tank off the gun's tube and run it from a small HPA regulated bottle, then either trade for a 79 type or buy a Qb79 gas tube/tank block/barrel band/stock. CAn convert a 78 to a 79, but it's a lot more work and you're better off just trading/selling and starting with a 79.
#3. If you want to run the gun you have from a large HPA regulated tank, seperate from the gun but attached by a remote line, all you need to do is put in a "bulk fill" end cap and hook up to the HPA tank.
I will again mention that it would be best to stay at CO2 pressures. Perfectly confident that 850PSi or air is no more stressful than 850PSi of co2. Some people are fine with anything under 1100PSi out put, I'm just more conservative.
This message has been edited by gubb33ps on Jul 3, 2009 2:24 PM
Thank you! That's what I needed to know - I don't want to over power the gun. Wasn't sure if the fittings were right - I'm trying to keep the pressure the same, not go up and down. Thanks for the info
JK's Airgun Forums, moderators, and administrators are not responsible for any problems that may occur from reading or using content posted on this forum, as they are the exclusive responsibility of two parties: the person who posted it and the person who acted on said posted information.Use of our forums from people under 18 years old only with legal guardian(s) present.
