Hi everyone ,
Have this B-51 I have started to work on now , its unfired , just some stock work done so far , want to shoot it before I decide if it needs internal mods or not ( which I am sure it will , hee hee hee ) .
Question is I am without a Pump , looking to purchase one and am wondering what Brand I should go with ?
Pyramid Air sudgested I buy the Axsor 3 stage . With QD adapter I am looking at
$250-ish . I will also be filling a 2009 Sam Yang .45 Caliber Rifle .
What say you !

[IMG][/IMG]
[IMG][/IMG]

Thanks , Alan

also get at least one rebuild kit....

Can you tell me who sells the Axsor rebuild kits and how much they cost?
I have one and would like to be able to rebuild it if necessary.
Thanks.

"I'm a lead farmer, motherf***er!"

as sold, they use a lot of air, and need a fill above 3000 psi. Not hard to make them run well at 2500, but you'll have to give up some power.

I guess I must be on the right track for the Brand of pump then ? Of course eventualy I want Scuba Gear , but that's a wayz off .
The guns mostly going to be used for Hunting rabbits , so really only need one shot each trip , maybe two if I see two rabbits that day . I got my rifle in .22 because of the added knockdown power . It would be nice to get it regulated to get lots of shots at a satisfactory FPS though too if I want to sit and target shoot also at times , which I very much enjoy . I generally use Gas Guns for that though or my Springers . The PCP gun is a new thing for this shooter so just learning what I need and stuff right now . I appreciate the advice and sidgestions alot , thank you .
One shot one kill is the primary objective of this particular rifle as is my Sam Yang .45 Rifle . I realy enjoy the ease of my Gas guns for targets though , got a couple , the AR20 and the QB's . I can't see the PCP's ever being as easy unless you have a compressor or Scuba Gear though . So for awhile I think my PCP's will be stricktly Hunting machines .
Once again , thank you for your replys .

Alan

Considered the Hill Pump? Depending on where you live and the humidity level, you may want to consider the Dry-Pak option. I don't know the cost compared to the Axsor pump. Just a suggestion

 

Nathan

I have considered it , it is the msot expensive, but I ehar its the best too , England made, hard to go wrong there . My Climate is VERY wet and Humid , not sure that matters , I had no clue that made any difference ? Can you tell me why it does ?
Thanks , the Hill pump is certainly an option for me money wise .

Alan

will make the insides rust, you will need the dry-pak....

mailto:flyingdragonairrifles@hotmail.comhttp://www.airgunartisans.com/flyingdragon/

as useual , I appreciate it !

Alan