Ford 335 "Cleveland" Series Engine Forum: Build

Return to Index

Build September 12 2011 at 2:55 PM		Andy (Login C_andy460) Member from IP address 204.31.128.185
Response to My 4v build... Hot street/drag...

The Crane Cams F-246 is a good solid lift cam for the Cleveland and works with a Torker intake. I would try to get as much compression as possible for it by zero decking the pistons and shaving the heads. Andy

Responses

Thanks for all the help so far!! Here is where I'm at! - Jim on Sep 12, 2011, 4:02 PM

I ran almost identical combo! - Steve.k on Sep 12, 2011, 4:29 PM

Re: I ran almost identical combo! - Jim on Sep 12, 2011, 4:50 PM

NO2 - Andy on Sep 12, 2011, 9:24 PM

F246 VS f238 - Jim on Sep 12, 2011, 10:32 PM

4.010"? - Brent Lykins, B2 Motorsports on Sep 14, 2011, 10:34 AM

How bout these. Brent? - Jim on Sep 14, 2011, 12:14 PM

Here's the thing..... - Brent Lykins, B2 Motorsports on Sep 14, 2011, 12:25 PM

Re: Here's the thing..... - Jim on Sep 14, 2011, 12:40 PM

Re: How bout these. Brent? - James K. on Sep 14, 2011, 7:50 PM

More standard bore forged pistons - Rich Carlisle on Sep 14, 2011, 10:02 AM

Kb177 - Steve.k on Sep 14, 2011, 10:50 AM

Re: Kb177 - Jim on Sep 14, 2011, 12:16 PM

Rpm is no problem. - Steve.k on Sep 14, 2011, 1:21 PM

Re: Rpm is no problem. - Jim on Sep 14, 2011, 3:08 PM

11.80 IS possible, I'm doing it ... - Danford1 on Sep 14, 2011, 12:17 PM

Have a set of standard TRW forged - Rich Carlisle on Sep 14, 2011, 1:06 PM

Re: 4.01" - tinman on Sep 14, 2011, 2:10 PM

Standard bore pistons - Andy on Sep 14, 2011, 2:43 PM

Re: Standard bore pistons - Jim on Sep 14, 2011, 3:06 PM

Re: Have a set of standard TRW forged - Rich Carlisle on Sep 14, 2011, 3:59 PM