Return to Index  

End play and more videos

December 9 2011 at 2:25 PM
  (Login danford1)
Member
from IP address 71.227.30.126


Response to Well....
Yes, I have excessive end play.
Here is a series of videos I just uploaded to youtube.
They are short, about 1 1/2 minutes long so it won't take a lot of time to watch them.

Gear bottom surface check
http://www.youtube.com/watch?v=yDbQbC2A6Qg

Shaft run out test
http://www.youtube.com/user/dstolarc?feature=mhee#p/a/u/1/JOmB87r2LoI

Gear tooth check
http://www.youtube.com/user/dstolarc?feature=mhee#p/a/u/2/Kkhyb16Lb_0

Timing gear swap
http://www.youtube.com/user/dstolarc?feature=mhee#p/u/3/YLmG7AUCim0

Timing gear comparison
http://www.youtube.com/user/dstolarc?feature=mhee#p/u/4/17t84BkUqtI

Shaft to block hole check
http://www.youtube.com/user/dstolarc?feature=mhee#p/u/6/ABoDp2zfz3o

Gear to block check
http://www.youtube.com/user/dstolarc?feature=mhee#p/u/5/Kq4IAWe-F-E

I also measured the front cam bearing to cam oil clearance. I have 0.004" oil clearance. I "think" that is OK. I'm not sure what that clearance should be.
I'll change the cam bearings in the next build up.

Danford1


    
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:36 PM
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:34 PM
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:33 PM
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:32 PM
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:26 PM
This message has been edited by danford1 from IP address 71.227.30.126 on Dec 9, 2011 2:25 PM


 
 Respond to this message   
Responses