Ford 335 "Cleveland" Series Engine Forum: Cast Iron Exhaust Manifolds

Return to Index

Cast Iron Exhaust Manifolds December 17 2011 at 5:33 PM		(Login gpence) Member from IP address 75.38.114.90
Response to Getting the HP with exhaust manifolds...

Calls for small overlap, wide lobe separation angle. Run the Cobra Jet cam. 117 degree lobe separation angle, 47 degrees overlap. -G ____________________________________________________________ Pantera Photos \| 351C Historic Information \| 351C Technical Information If you use a 351C 4V powered vehicle for a grocery getter ... the eggs aren't going to make it home!

Responses

Re: Cast Iron Exhaust Manifolds - Jim on Dec 17, 2011, 10:38 PM

Re: Cast Iron Exhaust Manifolds - George Pence on Dec 17, 2011, 11:00 PM

how bout... - tinman on Dec 17, 2011, 11:42 PM

most blueprint cams - tinman on Dec 17, 2011, 11:13 PM

That King - George Pence on Dec 18, 2011, 12:39 AM

the main thing about manifolds - joe on Dec 18, 2011, 12:32 PM

Sanderson shorty might fit - Jim on Dec 18, 2011, 3:22 PM

Lunati still makes the CJ cam - Jim on Dec 18, 2011, 9:34 PM

Re: Lunati still makes the CJ cam - James on Dec 19, 2011, 2:01 AM

Re: Lunati still makes the CJ cam - Jim on Dec 21, 2011, 9:42 PM

Did you intall the shorty's? - zgw on Mar 11, 2012, 6:10 PM

Did you get engine running correctly? - Steve.k on Mar 11, 2012, 7:06 PM

vac dizzy - steve.k on Mar 24, 2012, 11:11 AM

Re: Did you intall the shorty's? - Jim on Mar 18, 2012, 1:06 PM