Return to Index  

408stroker?

January 17 2012 at 4:21 PM
Steve.k  (Login steve.k)
Member
from IP address 209.91.107.221


Response to Another builder's opinion....

Well we have talked about this a few times on here for sure! What are your reasons for stroker? I think most have come to the consensus that with today's camshafts, carbs and other goodies a 550 - 600 hp c-motor is not that big of a deal even without stroking. If your heart is set on stroker than go for the gusto. I would buy one of the complete Stroker kits offerd from the various builders. The iron heads are very close on power so unless you have a ton of money or no iron heads then yes a new aluminum is the way to go. I myself went to the 400 block based stroker and knowing what I know now(info gained from this site) I would've built a real stout stock stroke Cleveland. It would have been way easier. Good luck in your build. Oh ya the Keith black hyper pistons are of very good quality and I have used them in 550 hp motor with zero issues.


    
This message has been edited by steve.k from IP address 96.30.200.35 on Jan 17, 2012 5:11 PM


 
 Respond to this message   
Responses