Return to Index  

Not Bad though Zach

April 16 2012 at 11:08 PM
steve.k  (Login steve.k)
from IP address

Response to Dyno results

Zach I dont think you should be dissapointed to much!Thats excellant power on pump fuel plus you are not spinning it hard.I think timing would have picked things up probably around 36 total on Iron heads.I also think you need some 1 7/8 headers!That picked up 25hp alone on my 408.Your cam is a little small for me but I think yours would offer good street manners so maybe something you maynot like to change?I would have liked about .620 lift and 256-266 @.050 duration but its a little more lumpy?I think headers and timing get you within 15hp where you want to be?Also Strip Dommy will pick you up some power even though its a upper rpm manifold.In fact the strip made more peak on mine over the CHI but did cost a bit of tq down low?

ANyhow not to shabby just some tweaking and you'll be close!
Good job Zach! Steve

This message has been edited by steve.k from IP address on Apr 16, 2012 11:11 PM

 Respond to this message