Return to Index  

Those pistons are going to stick out of the hole about a 1/4"....

May 2 2012 at 2:09 PM
Brent Lykins, B2 Motorsports  (Login blykins)
from IP address

Response to About to claw my own face off

They assumed you were using this crankshaft in a 351W SVO block.

If you take the measurements: (4" stroke divided by 2) + 6.200 + 1.280 = 9.480". It would be about .020" below deck on a 9.500" block. It will stick about .280" out of the hole on a Cleveland block.

Your only option at this point is to sell it all and start over with a Scat assembly....or buy a set of 408 Cleveland pistons, some 6" rods, and have a machinist turn down the counterweights so that they will clear the piston skirts.

Brent Lykins
B2 Motorsports, LLC

 Respond to this message