Return to Index  

no help here

June 14 2012 at 1:05 AM

tinman  (Login tinman351)
Moderators
from IP address 69.246.218.44


Response to Thank you George

sorry, the gaskets that are accessible on my 2V heads are 4V Doh!

but yeah the roof of a 4V port is higher than a 2V, and the floor of a Parker 4V is higher than the floor of both the 2V and 4V so Georges diagram thang is representative hight-wise...

but i was wondering if the port sides actually align or if they're offset some due to difference in width and or location, maybe one side pretty much lines up and the other is off?

or is the Parker port width about the same as 2V?

there'll be phantoms, there'll be fires on the road... and the white man dancing

 
 Respond to this message   
Responses