Return to Index  

Thanks David!

August 15 2013 at 7:50 AM
steve.k  (Login steve.k)
Member
from IP address 209.91.107.231


Response to I hate cast pistons.......

So you are saying you have broke them from non grouted but not after being grouted! You also mention that the p/s racers did in fact use prepped stock blocks like the ones I mention Paul Jenkins used. It is interesting to note that the block was not the big issue. It was poor grade valve springs that lasted usually only about 4 rounds. It would seem to me if you have to grout both the Windsor and the Cleveland why not just use the Cleveland why not have the added Benifit of the high speed bearing journals and main journals ! Paul and I discussed block prep and like you say once done correctly you have a solid base. I was surprised when he mentioned this as I assumed most everyone furnaced brazed blocks. Paul mentions not everyone had lots of money so things were tight and they used what they could afford. Thanks Steve.


    
This message has been edited by steve.k from IP address 209.91.107.231 on Aug 15, 2013 8:02 AM


 
 Respond to this message   
Responses