Yes ...times three!September 12 2013 at 3:29 AM
|bigal (Login xdgl358)|
from IP address 184.108.40.206
Response to Is degreeing REALLY necessary?
It ensures you have the correct part/grind and that its fitted correctly.
Some cam makers grind advance into their cams like comp cams but others like crane dont.
I just fitted a crane H-288-2 last year and it was about 2-3deg retarded. So its worthwhile.
And also as falc67 stated its a good idea to verify TDC on front pulley for ign timing setting. I actually ground about 2mm from the edge of my timing pointer so when timing engine with light the angle im looking at timing marks on gives me a true reading!