<< Previous Topic | Next Topic >>Return to Index  

Tim Meyer

September 4 2013 at 12:31 AM
ZZ28  (Login ZZ28)
4V
from IP address 98.214.214.243

Tim, do I remember a post from you regarding a 400 inch engine based on the 8.2 deck Windsor block? From what I recall it had a 4.25 inch bore and 3.6 stroke but has pretty thin walls even with the siamese bores. Is this correct or was I maybe a little intoxicated???

 
 Respond to this message   
AuthorReply

blizz
(Premier Login blizzardND)
Member
69.9.217.238

TMeyer..

September 4 2013, 7:39 AM 

Tims on his way back to MN today from Tod's shop in Ohio, he's stopping in Detroit on the way home, so it might be a bit b4 he can answer this...
~blizz

351C.net, Just say no to multi groove keepers..

 
 Respond to this message   
TMeyer
(Login TMeyerInc)
Member
74.40.138.150

Re: Tim Meyer

September 5 2013, 12:17 PM 

I don't know of a SBF that will go that big.
I have seen 4.180" on a FRR block.

 
 Respond to this message   

Falcon67
(Login Falcon67)
Member
209.165.224.67

Big small block

September 5 2013, 1:10 PM 

About the max you can do with a Dart is around 4.185 bore x 3.5 stroke in 8.2 deck. That's 385. The FRPP blocks can be had with 4.125 max 3.4 stroke so around 363 is about the max.

1967 Falcon 4 door 351C-4V
1970 Mustang 351C-2V
http://raceabilene.com/kelly/hotrod
Owner built, owner abused.


    
This message has been edited by Falcon67 from IP address 209.165.224.67 on Sep 5, 2013 1:13 PM


 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index