Yep, I've already tried that butJuly 28 2008 at 1:11 PM
Response to Re: Yes, SIM is running, but
Space gets dangerously tight against the Bosch connector and I have to release the board
to use it.
I'm afraid I'll have to solder the wires directly to the PCB. I'll show it when done and
it should still look sturdy and professional.
I suppose I could make an adapter to go from the Bosch to a 37 pin D connector...
I ordered the StimJim for this very reason, as it has screw terminals on it for this
As a side note: The StimJim is going to serve as a calibration tool for our tachometers.
I'll (uhh, again) have more on that later on.
The serial port however, is another story. I'm going straight up (not out) with that so
I can try different devices. (internally) Again, more on this forthcoming.
Too much fun! -Bob Brown
|This message has been edited by b-brown on Jul 28, 2008 1:13 PM|