SeaDoo Merc 240EFI JetBoater's Forum: It was not 6mm

Return to Front Page

It was not 6mm October 20 2009 at 3:08 PM		perrytime (no login)
Response to stripped the 6mm Hex plug for lube change jet drive

after looking at parts list, i see the plug is actually 1/4 hex. the 6mm was really close, and so far I am to scared to pull hard on 1/4 hex wrench since I have stripped away some metal, maybe I will get a 1/4 hex socket drive so I can hammer it in before turning with breaker bar. maybe with a socket drive I could get it mated to hand impact driver.

Respond to this message

Responses

You have several options, none of them that bad... - WAJetboating on Oct 28, 2009, 3:25 PM

Find more forums on Boating

Create your own forum at Network54

Legal Information: This SeaDoo/Merc 240EFI JetBoater's Forum is NOT affiliated with any JetBoat companies. It is merely a place where 240EFI Jetboat owners can post questions, answers, and opinions. Any and all comments, recommendations, suggestions, and/or any information seen on this forum is protected by our Rights of Freedom of Speech. This forum can not be held responsible for information that is learned here that may cause harm, or financial loss, to any person(s)and/or JetBoat(s) alike. Please use your common sense and post/read responsibly ... Thank You and Enjoy!