Respond to this messageReturn to Index
Original Message
  • Re: Cylinder Gap
    • Andrew (Login spEKTre)
      Posted Sep 27, 2017 8:56 PM

      I initially cut the cylinder gap on this Bull Barrel to 3 and a bit thou, shot it and found after about 50 shots the lead build up was scraping on the cylinder face and was snagging up the trigger pull. I then cut it to 5 thou and the problem went away, I noticed no discernible accuracy difference between the closer gap and the final cut. The interesting thing is the standard PF load I use which runs about 900 FPS in 3 revolvers is going 950 consistently in this barrel.
    Login Status
  • You are not logged in
    • Login

      Provides additional benefits such as notifications, signatures, and user authentication.

      Create Account
    Your Name
    Message Title
    Message Text
    Enable formatted text (what's this?)
    Notice: This is a moderated forum. Your post will not show up until a moderator approves the message. If you regularly have full posting privileges, you may have to login first.

    Find more forums on Law EnforcementCreate your own forum at Network54
     Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement