<< Previous Topic | Next Topic >>Return to Index  

Info for Dillon 1050 owners

June 29 2005 at 6:00 AM
No score for this post
max  (Login maxwell45120)

 
As a dedicated revolver shooter the main problem has always been misfires, until I bought a Dillon 1050 and made an all important modification.
Over the priming station in the tool head is a blank hole. I tapped it out to 5/8 gas thread and turned up a hollow die that is screwed down to touch the shell plate when the handle is at the bottom of the stroke.
This will prevent the shell plate flexing up as all other presses do when priming. You can now adjust the primer seat to be just below the case head reliably every time and no more misfires.
I sent a fax to Dillon to tell them that it works great and not a response was heard.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  
Find more forums on Law EnforcementCreate your own forum at Network54
 Copyright © 1999-2017 Network54. All rights reserved.   Terms of Use   Privacy Statement