Fellas -

Need a driveshaft for my '66 convt - 390 with toploader. Should be 57 7/16" from center to center.

Have a 289/C4 and a 390/C6 shaft to sell or trade.

e mail me if you have something.

Thanks!

Scott

Scott,
After looking around I have a driveshaft on a '66 Fairlane 289 stick car that's sitting out back. It's about 58-3/4 inches with the smaller yoke. You can get dual pattern u-joints. It may be a bit long but you can get shorter rear yokes to compensate. Let me know if you're interested. I'll be leaving for the weekend on Friday afternoon and returning home Sunday afternoon. Just so you don't think I'm ignoring you if you respond.


~~~~~~~~~~~~~~~~~~~~~~~
Doug Bender
1966 Fairlane 390/4-Spd
~~~~~~~~~~~~~~~~~~~~~~~

Doug -

I think I found the correct driveshaft, but thanks for checking.

Scott

67 Fairlane 500 hdtp, C4, 9", 800 hp 514
66 Fairlane 500 convt, toploader, 9", built 390
427 Side Oiler Tunnel Port 2x4 - looking for a 64 Fairlane sedan to drop it in!

Scott,
I'm glad you found a correct shaft.


~~~~~~~~~~~~~~~~~~~~~~~
Doug Bender
1966 Fairlane 390/4-Spd
~~~~~~~~~~~~~~~~~~~~~~~