Hi ... I found these pistons on Ebay ... Do some of you know these wiseco pistons...or is it not a good choice ..?? http://cgi.ebay.com/ebaymotors/Nissan-FJ20E-Pistons-Wiseco-90mm-Skyline-240RS-FJ20ET_W0QQcmdZViewItemQQcategoryZ33623QQihZ008QQitemZ180002339328QQrdZ1QQsspagenameZWD1V

If you're in the USA they might be ok,but if you're down under they can be sourced locally for cheaper. Dunno about the "Nissan/Holden" bit? :P

Hi anthony.. I am from denmark my english is`nt so good .. what du you meen when you say "dunno Holden/nissan"

Cheers

S-power

Sorry mate.If you check the E-bay listing,it say suit Holden/Nissan...As you'd know there was no Holden FJ20!

Ok there you got a point...

S-power

And A 240RS piston wont go anywhere near an FJ20.....
So yes, proceed with caution....

Ok thanks guys.... THen i will try to find some other pistons... Thanks

I have wiseco forgies, no problems so far, cost me about $950 for the set with wrist pins and rings.

Ok .. what pressure du you run on your engine??? Where did you buy these forgies ??



S-power

I bought my forgies from sparco, they are a wiseco dealer, I don't have the number, but try searching the yellow pages, I run 18 psi, and had no problems. Wiseco's have been around for years, and I haven't heard anything bad about them. You can check the range at wiseco.com.

Ok sounds great.. Thanks