<< Previous Topic | Next Topic >>Return to Index  

fj20e rebuild

September 15 2017 at 1:44 AM
No score for this post
pete  (Login smudge2031)
from IP address 2.223.2.40

 
ok, so Im from the UK and want to rebuild my fj20e with carbs. Looking to raise the compression to 11:1 . my question is where do I get forged pistons 89mm, highlift cams and also a full gasket set ?? thanks

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply
Anonymous
(Login NBF823)
73.154.232.25

Re: fj20e rebuild

No score for this post
September 15 2017, 10:39 AM 

Unlucky for, I'm an American, and we probably know less than Brits as we never got an FJ through Nissan.

I'll try though.

Pistons;
I think Kameari is the only place I've ever seen High compression Pistons listed. Also, some have used Mitsubishi V6 pistons. Spool lists piston kits, but most are for turbo motors, but I know a lot of the manufacturers listed on his site will probably make any piston you want, and they may do it cheaper than Kameari. Are you sure you can get away with the stock 89mm bore?

Cams;
As far as I know, only Ashford makes cams. Other than him, it's finding a used set, which is rare, or regrinds.

Gaskets;
I believe the only place currently listing FJ gaskets is SW motor sports. Stewart Wilkens I believe. This doesn't mean they aren't out there, but there not all over the place.

There's a lot of information on this site - search. You'll find that a lot of the sources are old, and not many people post here any more, but there's a lot of technical data hidden away in the forum.

One thing I noticed about the FJ, short of relying heavily on the Austraians, is that there doesn't seem to be a one shop stop that I know of. That doesn't mean that there isn't and I havent found it yet. But over here in the US, you can call a place that does specific motors, and you can get every part you need or want. When it came to my FJ, my Pistons, cams, rods, timing chains, harmonic balancer, bolts, etc - all cam from different sellers. I'm not aware of getting two different parts from the same guy to be honest with you. Sw probably has the most stock replacement parts, and spool probably has the most bottom end parts, and I'm guessing Ashford on the top end stuff - you'd have to investigate further.

Good luck!

 
Scoring disabled. You must be logged in to score posts.
Anonymous
(no login)
203.97.70.10

Re: fj20e rebuild

No score for this post
September 22 2017, 6:42 AM 

spool do a custom piston rod combo in aussie great service i have ordered off them twice
custom bore compression CP pistons and its reasonably priced

cams try kelford cams in nz

 
Scoring disabled. You must be logged in to score posts.
 
  Respond to this message   
  << Previous Topic | Next Topic >>Return to Index  
Find more forums on Network54Create your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement