Total rebuild,power tuned with Quest spring,new piston seal,honed cylinder,transfer port modified,deburred,polished spring with bronze washers at each end,trigger job,tar and moly to internals/trigger,chopped barrel 5 inches recrowned and .005 choke added,refinished stock,added brass muzzle break(home made),BSA 3X9X32 scope.Shoots hard and very accurate.When I got it,,, it looked like a shotgun blast hit the target after trying to sight it in LOL.One high,one low,next left then right.OK time to sweeten it up I'm thinking.I got a Quest spring and the knowlege and for $25 I have nothing to lose.
BBGun Bob
The way I got it
[IMG][/IMG]
During rebuild Quest spring on top
[IMG][/IMG]
After Chop and stock refinished
[IMG][/IMG]
Home spun Muzzle Break
[IMG][/IMG]
Finally after many hours its done
[IMG][/IMG]
[IMG][/IMG]
[IMG][/IMG]
Springers are Neat! One Shot One Bullseye!
Posted on Feb 23, 2008, 8:51 AM from IP address 69.14.147.184
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]