recoil pad will fit an RWS 34? Got a 34 and would like to get a pad as close as possible to the overall dimensions. Any other suggestions appreciated.

TIA

AW

Not hardcore yet, but I'm getting there.

The butt of a 34 stock is curved. Most guns with recoil pads are cut square before the pad is fitted. Your best bet for a pad on a 34 would be a slip-on, unless you want to square off the stock and add a fitted pad.

if the stock 36 pad will then fit.

Thx.

AirWad (Dave)

Not hardcore yet, but I'm getting there.

Hi Dave. I put a rubber slip on pad on my 34 and it works great. Think I got it at Wallyworld for $10. It also goes up the stock about 4 inches which adds extra prtection to the end wood.

Don

The 36 and the later 34 stocks T-05 are almost identical.
I would think you could cut the butt off straight and use a 36 recoil pad. The older 34 stocks are dimensionally different.
Tom

,

I picked up a brand new 34 in a trade but didn't like the wood butt so I installed a Morgan adjustable. Picked it up used on ebay for 20 bucks.

It's very easy to install because it requires a straight cut. Completely changed the lines of the 34 and it fits much better.

Think Straight, Talk Straight