Hi

I have a 2 scopes 1 is on my .34 that is .177 and it is RWS Modle 350 which is a 4 x 32 with no AO and on RWS C-Mount

The other is on my 34 that is .22 and it is a model 300 4 x 32 WITH AO . and on a RWS C-mount.

Both scopes are fine but the Model 300 is a FAR BETTER and LARGER SCOPE .

I would like to know who MAKEs RWS scopes , or do they actually make their own scope ?

The Model 300 so far sure is a nice scope and goes for around $ 150 --$ 190

Thanks Jerry

Jerry,

What is the minimum focusing distance of the RWS 300 scope?

Some Chinese-made scopes are quite good, for the money, nowdays. But then, there are Japanese-made ones that are foggy.

If the RWS 300 focuses down to 10m, I may consider it.

Regards,
Nikos

I have used it down to about 25 Foot.

I havn't had the chance to try it out any farther than about 75 foot.

This is a 4 X 32 Scope But Does have AO It's very Clear and Bright and Sharp. the cross hairs are a LOT finer than whats in the RWS 350 Model.

The whole scope is a bit longer and just has a better quality look to it .

It uses 1 inch rings .... I am Using the RWS C Mount ..... I don't know who makes this cope and or RWS C-mount as it don't say China . Japan , or Germany ????? soooo

The scope ( 300 ) lists anywhere from $ 160 - $ 190
I got a real sweet deal on mine for $ 90.00 The box flap was ripped a bit and there where no papers .

Jerry

i just got my 300 in the mail . on the box it said , made in china. hope this helps . and i love mine . crystal clear . hoot

Hello,

I recently bought a Diana 350 .22
Do you think the 300 scope, if mounted in a Diana C-mount would be strong enough ?

Kind regards,

Joris

Joris

I have both RWS Scopes 300 and 350. The 350 (cheeper one ) is a good scope so far . BUT the 300 is a far better scope.It is clearer and has finner cross hairs and is a longer tube and has AO.

I have the 300 on my RWS 34 in .22 Cal. I have about 1500 shots through it . It is mounted with RWS 1 C Mount.

I would use BLUE Lock - Tite on the Gun to stock screws and the C-mount screws and the scope rings screws . On the C-mount there are Very small locking screws I don;t think I'd use the lock tite on them .

ALL of my screws have loosened up already . I have NOT Lock -Tited them yet as I am going to do a JM Tune up . Once I am done with the tune up I will lock tite everything in .

Jerry