Have a 48 in .20 cal. and have never been able to get good groups out of it even after break-in period...and trying all pellets....found out after disassemble that the breech seal has a broke area about 1/8th of it at bottom and was wondering whether to have it repaired under warrany or just order a new one and replace it myself and how hard is it to get and replace vs. warranty and cheapest route being it is apart on the bench as i speek.....an info on how/where to go about this is greatly appreciated.....Mike......
Since it seems like you know enough to take it apart, it might be cheaper to buy the seal and do it yourself. The shipping to the repair center in Arkansas is probably about $20 and if I remember its about $25 to get it home. Cost of a small seal and its shipping is probably less than shipping of the gun 1 way. AND you don't have to worry about stock damage during shipping...
I love my 3 RWS/Dianas (24,34,54) and the scopes...
Thanks for the info.....thats what I had thought but did not know how to remove the seal that is in the face of the compression tube....looks to be pressed in or someting...poked at it with dental pick...but did not try to force it out....maybe that is what is needed to remove????any help would be appreciated for install.....also looking for any suggestions on what to polish and or trick out while I have this apart.....will soon be installing gsi spring and guide also and just what a head start on tweaking for proformance.......Mike.....