Last night Umarex was closed when I called- so I went down to my dads and we found a steel rod that fit so I cut, sanded and drilled a tiny hole in the center-made a locking 'key' to fit it and blued both pieces-the 36 is up and running and looks factory fresh! My friend is picking it up tomorrow night-as an airgunner I want to start being more self reliant(when possible)-Ray, your offering to make the part was very appreciated and it launched me into action Thanks again for the both of your inputs and kindness! CarlM

Hey Carl,Way to go! You used the same aproach I would have! Its a great feeling to help an airgun friend. Glad to hear she is back up & runnin! I would have done the same,but I would keep an eye on it,not so shure oem pin is not "hardened"?? I dont know. Good shootin Carl,Tim. P.S. Now I must GET AWAY from this "puter" long enough to install the trigger I got from Ctruth on my buddys gun!!

Glad you got it, like tim said it could need hard pin just watch it you will be good im sure.
The offer always stands to all my friends here if needed, just got to let me know if i can help.If you can draw it, i can build it.
Ray

Hey Ray, Tim here. Very nice offer from you,dont be supprised if I someday take you up on it! Your generous offer to help others here is one reason I am so loyal to my friends here. Way to go Ray. Tim. P.S. Im alittle concerned about that "pin". Just seems to me it should be hardened,& to a VERY close tollerance??

Tim your right it will wear but the pin will not hurt the mating part, it will be hard so pin will wear but prob wont hurt anything.
Can always make one from tool stl.

Hey Ray, thanks "again". Was just thinking I make my little "backyard" repairs allthe time. Can save aweekend of hunting or paper punching. Just thinking Carl might want to follow up w/ a call to Umarex/RYAN! to order what is most probly an off the shelf VERY inexpensive part. My hats off to Carl for getting his friends gun up & running! Tim.