Hi guys,on my last post asking quetions for bedding and after watching the pdf that Dave
emailed me,i saw the bracket that holds the front stock to reciever and i thought since
i`m going to do the work,i have new bracket that had ordered it in case and decided to
change it,but the damn screw that holds it is so tight that none of my regular screw drivers
can open it.is there some type of locktite that they use or what,i`m almost damaged the screw
so i don`t want to strip the head.what should i do without going and buying special gunsmith
screw driver set.thanks.

I use a KD Impact screwdriver. You pound it with a dead blow hammer and it pushes in and twists at the same time. You need to protedt the other side of the gun from damage - I usually hold it in my lap...