Can anyone give me help concerning my Hitachi 43uwx10b TV,I have a problem with the blue gun alignment with this set, I have performed the DCAM convergence proceedure and came across a problem with the blue lines. While in the grid mode I was able to adjust the red and green dotted lines in all four directions at all grid points, but the blue dotted lines will only move left and right not up or down. The solid blue grid lines have a serious curvature towards the center the red and greenlines are fine. Are there any techs out there that know what board or more directly what component on that board controls the blue line on the grid, I beleive if I know what to replace I can repair it myself. Thank you for any help you can provide!
Scoring disabled. You must be logged in to score posts.
What and where is the vertical stk? do you know the part # and location in the TV. I think i can replace this if I know where it's located in the set. Thanks, Terry
Scoring disabled. You must be logged in to score posts.
First you need to have good soldering skills. if you can find a schematic look up the parts list and find the convergence ic part number then call an electronics distributor and ask for assistance. be sure to look up the location number too.
Scoring disabled. You must be logged in to score posts.
First you need to have good soldering skills. if you can find a schematic look up the parts list and find the convergence ic part number then call an electronics distributor and ask for assistance. be sure to look up the location number too. p.s. it is not called the vertical stk
Scoring disabled. You must be logged in to score posts.
