tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 TV repair forum - Open   
See our courses below


 
       
  << Previous Topic | Next Topic >>Back to main  

Symphonic WF02130

August 7 2007 at 11:27 AM
No score for this post
  (Login frank2007)

I'm having trouble finding a fault on this TV/VCR combo SYMPHONIC WF02130, It starts up runs good for about 15 seconds then turns itself off, checked all components and seem to be ok. anybody experienced this problem? Thanks in advance.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply
Mike
(Login mikemaietv)

cCommon problem

No score for this post
August 7 2007, 2:37 PM 

A common problem with these little pieces of crap is the vcr section is trying to load the tape, binds up and shuts the set down. It it will take a tape and play it more than the 15 seconds then the unit has a tape loading problem, that could be a simple timing or slipping belt, or a dirty load switch or a bad tape sencer

 
Scoring disabled. You must be logged in to score posts.Respond to this message   

(Login frank2007)

Re: cCommon problem

No score for this post
August 7 2007, 3:48 PM 

You wright Mike,it's a tape load switch that would come off it's place, i was able to put it in place, and took out the two main belts so the vcr is disable. no need for VCR Thanks.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - Symphonic WF02130
  << Previous Topic | Next Topic >>Back to main