I have a phillips 8p5434 c101 projection tv, with a ptv805-ah01 chassis. Got this set for free because the picture was blurred. They upgraded there set. I pulled the screen and cleaned mirror. Then noticed lens were clouded right up. Pulled cover and didn't know there was liquid in them. A little of the glycol got onto the board below. I immediatly pulled board out and cleaned very well with alcohal and q- tips. No power at all was turned on or even plugged in when became wet. I installed the board back in and turned tv on. Get absolutely nothing! The leds by the switches do nothing. I checked fuse checks out fine. Have no smell at all so i don't believe anything got burned. Any help would be appreciated.If someone has a schematic i would greatly appreciate that also as i have a little electical knowledge.'
thanks alot
Scoring disabled. You must be logged in to score posts.
Pull each crt separately, drain fluid, dis-assemble, clean, reassemble, refill with fresh crt fluid then re-install. After doing his, completely re-converge the unit from scratch. To accomplish this, buy a template from Magnavox to put over the screen. Reconvergence instructions are provided with the template
Scoring disabled. You must be logged in to score posts.
