tv repair shop software
 

Software for repair shop
Assist Control



Free trial

tv repair

 TV repair forum - Open   
See our courses below


 
       
 


  << Previous Topic | Next Topic >>Back to main  

phillips turns off

February 14 2008 at 1:11 PM
No score for this post
  (Login be_vos)

 
have phillips 32ps55s321 chassis 32t800 turns off after few seconds any suggestions

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply

(Login waitedk)

Anyone find the fix for this

Score 1.0 (1 person)
November 13 2008, 2:35 PM 

I have a Phillips with the same problem, has anyone found a fix?

Thanks
Daryl

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
rrobor
(Login rrobor)

Re: Anyone find the fix for this

No score for this post
November 14 2008, 3:45 AM 

Philips invented a thing called I sq C. this is protection that if something fails the set shuts down. How it works is a pulse is sent out through all the chips then back to the processor. If a chip fails the pulse goes missing and the processor shuts the set down. The usual is the vertical chip but unless you know the set and read voltages on the bus lines its a guess.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   

(Login be_vos)

Re: Anyone find the fix for this

No score for this post
November 18 2008, 5:01 PM 

if you hav a variac ac plug try turing voltage down to see if set stays on if you dont you could try turning g2 down slightly (by the focus on back of set ) you have to be careful and dont over or turn down g2 to much

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - phillips turns off
  << Previous Topic | Next Topic >>Back to main  
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement