BBairguns.com Airgun Collector and Shooters Board: Daisy Powerline 822 22x
 


  << Previous Topic | Next Topic >>Return to Index  

Daisy Powerline 822 22x

June 7 2003 at 4:21 PM
  (no login)
from IP address 152.163.253.3

 
I have a daisy powerline 822 that wont build up pressure. It pumps, but the air seems to go out the other side. What could be the problem? If it is a valve or seal, is there a repair kit i could get?Any help is greatly appreciated.

 
 Respond to this message   
AuthorReply
Mike
(no login)
64.169.108.225

You are not alone!

April 8 2004, 5:09 PM 

I have the same problem. let me know if you find a solution...I will do the same.

Thanks

 
 
RM422
(no login)
24.57.140.156

Re: Daisy Powerline 822 22x

April 8 2004, 7:24 PM 

that is a common problem with most pneumatic pumps. it leads me to believe that it is most likely the seal. i accidently over oiled a pumpmaster 760 and the seals are screwed now and the gun won't hold air.

 
 
Billie
(no login)
4.14.163.250

pneumatic seals

April 9 2004, 9:38 AM 

pneumatic guns should always be stored with pressure against the seals to hold them in place otherwise they will shrink and dry out.

 
 
RM422
(no login)
24.57.140.156

Re: Daisy Powerline 822 22x

April 9 2004, 9:43 AM 

so you mean to store them pumped.if thats what you mean can't the spring inside where out from too much pressure?

 
 

(no login)
67.76.10.99

Pump up guns

April 9 2004, 11:24 PM 

Hi Ernie. Are you cocking the bolt so that it is open, then pumping it up. You must cock the bolt on the Daisy guns to close off the firing valve so the pressure will not leak out. If that is not you problem then you need to reseal the gun. There are 7 seals and O rings that need to be replaced. I have them in stock but the are a very tricky gun to reseal, right. Email me and I will try to help you. Thanks, Ron Scalzo

 
 
Billie
(no login)
4.14.163.250

Spring pressure

April 10 2004, 11:50 AM 

There is no pressure on the spring. The only pressure on the spring is when you fire and the hammer strikes the value stem. Then the spring is under pressure to return the value stem to the closed position. the gun does not have to be pumped up to full presure just a pump or two on multi pump guns. the small amount of presure inside the value holds the entry seal and the value stem seal in place.

 
 
RM422
(no login)
24.57.140.156

Re: Daisy Powerline 822 22x

April 10 2004, 1:13 PM 

ok i think i will try that with the 760. thanks for the info.
-RM422-

 
 
Current Topic - Daisy Powerline 822 22x  Respond to this message   
  << Previous Topic | Next Topic >>Return to Index  
 Copyright © 1999-2014 Network54. All rights reserved.   Terms of Use   Privacy Statement