I picked this small pistol up at a Flea market and I cant figure out who made it and how it works.There is a small lever that flips out from under the grips and seems to cock it.The only thing it says on it is Germany.
I dont think this is an airgun,It has a spring inside and its all metal but I think it may be a lighter.It really feels like a mini 22 firearm but I cant see how it would loaded,I have to take it apart tonight and figure this out.
Mike
bavaria55n (no login) 74.135.135.255
Pistol
December 11 2006, 6:18 PM
Is this a teargas/blank pistol or an airgun?
Does the rear of the 'slide' fold down to insert a 'clip' holding the teargas/blanks?
Gary is right - it's either blank (starter's pistol) or mebbe tear-gas.
Mike (no login) 24.58.173.73
Maybe a cap gun
December 11 2006, 10:15 PM
There is a small trap door that folds down on the back but it cant possible fire anything out the barrell because it pluuged.I think it may be a cap gun,The trigger assembly is nicer than a lot of 22 25 caliber pistols that I have seen.I cant beleive how well it's made for a cap gun.
Mike
bavaria55n (no login) 74.135.135.255
Pistol
December 12 2006, 7:16 AM
Is there a hole in the top of the barrel/slide?
Similar guns I have seen used a metal block that held the cartridges and slid into the back of the slide through the trap door.
I never fired on so I am not sure how they worked or what the ammo looked like.
Gary
Mike (no login) 24.58.173.73
Small hole
December 12 2006, 8:53 AM
There is a small hole on top,I tried to fit a BB in it but it's to small.This little gun has got me baffled.
Mike
(no login) 71.121.104.117
Blank starter gun
December 12 2006, 9:49 AM
What you have is a .22 cal blank starter gun. I have one just like it. It is supposed to have a carrier in the back of the slide that you load the blanks into and slide it into the gun.
Mike (no login) 24.58.173.73
Make?
December 12 2006, 2:59 PM
Do you know who made it?
Thanks
Mike
Mike (no login) 24.58.173.73
Thanks
December 12 2006, 8:38 PM
You are right.I found the clip inside the end.I think someone put it in wrong and it was stuck.Do you know how to use it?
Thanks
Mike
bavaria55n (no login) 74.135.135.255
Pistol
December 13 2006, 6:10 PM
If it is like the one I have, there are little 'studs' on the part that slides out of the barrel.
You place the blanks over the studs and put it in the rear of the pistol.
I am not sure if it feeds from front to back or back to front.
I think the little piece that folds out of the bottom of the clip is to pry the fired shells out of the slide.
