<< Previous Topic | Next Topic >>Return to Index  

Too much play (too easily rotates) in my GMT (1675) Bezel - what to do? Thanks!

December 5 2017 at 9:50 AM
Richard  (Login PSY76)
VRF Member
from IP address

 Respond to this message   

Ray Wu
(Login raywu)
VRF Member

Just making sure you have the genuine bezel spring

December 5 2017, 9:56 AM 

 Respond to this message   
(Select Login agra1976)

Show us a pic of it...

December 5 2017, 10:38 AM 

Did you change it before?

 Respond to this message   

(Login SubKingJ)
VRF Member

post a pic of the bezel and spring

December 5 2017, 11:45 AM 


 Respond to this message   
(Login Autaviano)
VRF Member

You can try to

December 5 2017, 5:37 PM 

Pop the bezel,, there should be a bezel retention ring under it, flip the bezel if you don’t see it, sometimes it gets stuck underneath. Take the bezel retention ring and fold is some so that it’s no longer completely flat. Place it back over the plexi and snap the bezel back on the case, this should cause some friction and resistance so that the bezel doesn’t freely rotate. You may have to give it a few tries until you find the right “tension”. Of course this is assuming there is a bezel rentention ring under the bezel wink.gif

Good luck!


 Respond to this message   
  << Previous Topic | Next Topic >>Return to Index  


Vintage Rolex Forum and Vintage Rolex Market are not sponsored by, associated with and/or affiliated with Rolex, S.A. or Rolex USA or any respective subsidiaries or affiliates.  

Copyright The VRF, Inc. 2002 - 2017