Return to Index  

That's a good notion, Kimosabe!

February 2 2004 at 6:50 PM
No score for this post
Paul Lovett  (Login Paul_Lovett)
Posters
from IP address 208.188.193.40


Response to Rubbing and "hammering" on that cam

 

Seriously, that's a geat idea. I used synthetic in my last motor, but it wasn't Amsoil. A 0W30 would make me a little nervous. A 20W50 would be fine. I wouldn't mind a 10W40 either if Amsoil carries it. I'll check their site.

I'm definitely a believer when it comes to using quality oil. I don't think non-synthetic can do the same job even if the oil change intervals are short and religiously done. Amen, Brother!

How long in your opinion should I wait to let the motor break in before switching to Amsoil? My cam is already broken in as I installed it in my last motor right before I took it apart. The rings and bearings in the new motor are all fresh, though.

Paul

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Responses

Find more forums on CarsCreate your own forum at Network54
 Copyright © 1999-2018 Network54. All rights reserved.   Terms of Use   Privacy Statement