<< Previous Topic | Next Topic >>Return to Index  

side oiler with tunnel port dual plane intake - comments?

August 3 2004 at 3:05 AM
No score for this post
Melzer  (Login melzer51)
Posters
from IP address 64.252.205.248

 
Found a 'fresh' side oiler for a new project. Have not seen (or heard) the motor yet but have limited info (no part/casting #'s as yet). Any comments would be appreciated.

a) side oiler block .015 over (no sleeves)
b) steel stroker crank 454 (aftermarket - not 428)
c) 'H' beam rods
d) Weisco forged pistons 10:1
e) tunnel port heads
f) orig dual plane tunnel port intake w/2 Holleys
g) Comp Cams solid lifter cam (grind not known at this time)
h) Aviad oil pan
i) no clutch/pp or bellhousing

The motor was recently built by a reputable engine builder and has 0 street miles according to seller. I can get documentation from the engine builder and hear it run at his shop. Seller wants 20k.

Thanks,

Melzer

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  
Find more forums on CarsCreate your own forum at Network54
 Copyright © 1999-2017 Network54. All rights reserved.   Terms of Use   Privacy Statement