Does anyone know if you can split the High Definition signal from one Sony HD 300 receiver to fit two HD televisions. I have a 65" mitsubishi and I am currently remodeling the kitchen and planning to put in a 17 inch hdtv flat panel. I want to split the HDTV YBG signal from one receiver to operate two tvs. I know they would have the same picture on the screen if this can be done. I can connect a second normal satellite feed to get a different picture but not HD.
Scoring disabled. You must be logged in to score posts.
A 17" screen, HDTV or not, will not look any better than a standard SD at 17". Bring the second feed to it and be happy. It's going to look very good anyway. You can't split the component feeds.
This message has been edited by Bobby_C on Apr 23, 2004 8:44 PM
Scoring disabled. You must be logged in to score posts.
If you just get 3 Y-adapters from Radio Shack, the images on both sets will look very dark. The proper way to do what you want is to get a Component Distribution Amplifier. These are pricey since the market for them is small. Key Digital sells one. Hopefully Google will find you some more. Check the bandwidth carefully.
Scoring disabled. You must be logged in to score posts.
RDH,
If I read the specs right, the Sony HD300 has DVI, RGB and Component outputs. Maybe you could run RGB to the flat panel and component to the big screen?
a
Scoring disabled. You must be logged in to score posts.
Current Topic - Splitting a HD tv signal for two Hd tv's?????
