Hi Guys. I'm new to this site so I apologize if this question has been posted before. I have an 02 Acura RSX type S and was wondering if anyone had installed The projector Bi-Xenon light assemblies on this type of car. I am told that you have to place the gutted head lamps in the oven to get the faces off but the way it looks too me is that the inner reflector for the low beam will have to be cut out and the Bi-Xenon light assemblies will have to be bolted to the inside of the outer case but by doing it that way there would be no way to adjust the light after. Any help or advise would be greatly appreciated. Thank. Paul

illusion-lighting.com has done it.

http://www.illusion-lighting.com/gallery/headlamp_phase_2/Acura/2002_RSX_r.html

well, i didn't do the RSX retrofit, but i did a Rx300 retrofit on my frz car, which is similar to your car which uses 9006 outer and 9005 inner...we use bixenons too.

We cut out a hole in the reflector area of the headlight, and just drill holes and mount the projectors onto the reflector surface so it can be fully adjusttible using the original ...er...switch??

I was wondering as to how you wired your lights. I have the 9006 and 9005, and the bi-xenon projectors. I would like to have the halogen 9005 high beams to flash only when the xenon low beams are off, and to not come on at all when the xenons are on. Any help would be appreciated.

Tim