Well afer about a month I'm finally done with this project.. here are a couple of pictures... It was very hard considering the amount of space I had. I had about 5 inches total already pushing the projector against the lens. I had to go with cutting a piece of each headlight and gluing a piece of plexiglass. Since the headlights are textured and there is no aftermarket cleared headlight for sale yet. I could not find anything to put around the projector so for now that is what I found a pieces of thick aluminum and just cut it to fit there. I had to finish because I need the vehicle now so. I'll figure something out later to replace the aluminum.. What do you guys think..
