The above featured our first horeshead bench. The two heads were carved seperately, the one on the right side is 4 inches shorter than the left one.
The below set was carved 3-16-03 using our horse, Angel, as a model. It took two pounds of carrots to keep her in place long enough to complete the carve.
In the above pic we had used a propane torche to burn the carvings, then brushed them with a steel brush.
Below we had put on a coat of stain.
Here is Lynn putting on a VERY HEAVY coat of sanding sealer.
Now they will get a few coats of poly and the backrest and seat attached.
See you at the 2004 Vous
later
waynecancarve
