The above featured our first horeshead bench. The two heads were carved seperately, the one on the right side is 4 inches shorter than the left one.
The below set was carved 3-16-03 using our horse, Angel, as a model. It took two pounds of carrots to keep her in place long enough to complete the carve.


In the above pic we had used a propane torche to burn the carvings, then brushed them with a steel brush.
Below we had put on a coat of stain.
Here is Lynn putting on a VERY HEAVY coat of sanding sealer.

Now they will get a few coats of poly and the backrest and seat attached.
See you at the 2004 Vous
later
waynecancarve

You want these on the step-by-steps?

Steve

Wayne and lynn. There more work than some may think. Question- Why is Lynn always the one doing all the work, we never see you doing anything. HEHE

now on the step by step page

Hey this will help me. Just got order for 2 heads as a farm entrance. THX bunches.

nice job i have two of them to do myself.
Thanks....... mikeB