- added a plate (200# each...4 total) Hopefully right at 6200#
- blocked rear susp. with fake shocks
- running 800 CFM q-jet instead of 750 holley
- upright headers, instead of manifolds with open pipes
- air psi from 30 all around to 35 rear/15 front
- 100 octane low lead av gas instead of 91 and booster
I did get lazy and am going to run hitched to the massive bumper point instead of a custom hitch. This is due to the VERY unfavorable schedule we got this year. I'll realisticly only get to one or two more pulls all year.
I will be using the engine in a drag truck though, I'll pick it up on the 16th.
laters,
A.......
This message has been edited by DieselEater from IP address 75.163.132.149 on Jun 8, 2007 3:44 AM
Alan (no login) 65.240.34.1
re schedule
June 8 2007, 6:51 AM
Any chance of picking up some more pulls? Good luck.
I wouldnt be surprised if Cttpa is tryin to phase out the stock and mod streets at their pulls. Seeing that they dont have many as they did last year. Plus the Platte Valley Tractor Pullers picked up the class now and have 10 points pulls this summer for them. They have pulls in Nebraska and Colorado. They only had one colorado one, this year and they already had it. Its who i pull with now. If you were willin to drive 6 hours you could pick up 3 or 4 more pulls
This message has been edited by Jimmy400 from IP address 66.168.136.8 on Jun 8, 2007 12:34 PM This message has been edited by Jimmy400 from IP address 66.168.136.8 on Jun 8, 2007 12:32 PM
HEY DIGGER!! Iv just herd from Glen Luessetto Mitchell will be doing street stock in mitchell. Weigh in/registration closes at 5 p.m., with classes starting at 6 p.m. Hope to see ya there
